• YOUR LOCATION : HOMEPAGE >> PRODUCTS >> MF FILTER CARTRIDGE

    PTFE Membrane Pleated filter cartridge

    PTFE Membrane Pleated filter cartridge

    Features & Benefits
    A. Hydrophobic PTFE membrane pleated cartridges with absolutely rated
    B. Cartridges consist of a PTFE membrane with thermally bonded polypropylene components to provide a very durable filter with only two materials of construction.
    C. Superior flow rate and efficiency maximizing performance
    D. Extensive applicability.
    E. Extremely good chemical compatibility
    F. Good oxidation-resistance,high temperature-resistance
    G. Remove particles and microorganisms greater than 0.2µm from gas and liquid
    H. Cartridges 100% integrity tested by bubble point and diffusional flow to ensure  consistent and reliable performance
    I. Flushed with ultrapure water to remove any manufacturing debris
    J. No adhesive,thermal bonded manufacturing without adhesives

    INTRODUCTION:

    Applications

    A. Solvent filtration
    B. Sterile vent filters for storage tanks
    C. Coating-solvent in the electronic industry
    D. Filtration of non-aqueous chemicals
    E. Filtration of acid baths for the production of semiconductors
    F. Compressed Gas
    G. Pharmaceutical and intermediate Solvents

    Material Of Construction

    A. Media:Hydrophobic PTFE
    B. Support layer:Polypropylene
    C. Core/Cage/End adaptor:Polypropylene
    D. Sealing method:Thermal bonding

    Recommended Operating Conditions

    A. Max.Differential pressure:
    B. Forward-70psi (4.8bar) at 25℃
    C. Reverse-40psi(2.7bar) at 25℃
    D. Filters change recommended at 1.5bar
    E. Max.Operating temperature:95℃

    Cartridge Dimensions

    A. Filtration Area:0.75㎡ each 10″length
    B. Outer Diameter:69mm
    C. Nominal Length:5″,10″,20″,30″,40″etc
    D. Micron Rating:0.1,0.2,0.45µm

    Integrity Test Values

    Micro Pore Size 100% Ipa Bubble Piont
    0.1μm 22 Psig (1.5Bar)
    0.2μm 15 Psig (1.0Bar)
    0.45μm 9 Psig (0.6Bar)
     

    Odering Guide 

    Model PTFE Micron Rating End Adaptor Seal Length

    PTFE -
    PTFE Pleated Type

    010:0.1μm

    020:0.2μm

    045:0.45μm

    CODE

    O - DOE Double Open End

    7 - 226/Fin

    8 - 222/Fin

    3 - 222/Flat Closed

    2 - 226/Flat Closed

    F - 215/Flat Closed

    S - O - Ring Insert/Flat Closed

    E - EPDM

    N - Buna

    S - Silicon

    V - Viton

    10:10"

    20:20"

    30:30"

    40:40"

    久热这里只有精品视频6